Master Base Primer

1.000.000,00 DKK

Item number:

Priming of wood before lacquering

  • Quick-drying
  • Minimizes side-bonding
  • Reduces penetration of tannic acid
  • Gives the wood a light colour

*The wood sample is shown on oak

5 L

Product details

  • Description
  • Specifications
  • Technical data sheet
  • Safety data sheet

Density:

1.00-1.10 g/ml.

pH-value:

pH 7-8

Shelf life:

2 years

Application Temperature:

+15-25°C and approx. 50% air humidity.

Coverage:

8-10 m²/L

Colours:

Colourless

Cleaning of tools:

Use water

Storage:

+10-25°C. Keep out of reach of children. Do not expose to heat (e.g. sunlight). Store frost-free during winter and cool during summer.

Packaging:

5 liters

Viscosity:

35-40 Sec. DIN Cup 4

Dilution:

Undiluted

Odour:

Faint

Solid content:

30-40%

Drying time:

1-2 hours at 20°C

Recommendation:

If drying times are not followed, this can result in poor adhesion and reduced resistance. For each layer of Master Base Primer, drying times will be increased. High temperature and low air humidity will reduce drying times. Low temperature and high air humidity will extend drying times.

Master Base Primer, Natural is a water-based, quick-drying wood primer. The primer seals the wood and minimises tannic acid penetration and side-bonding. It is only suitable for untreated or sanded surfaces for all wood types before treatment with other water-based WOCA floor lacquers.

Worksteps

Instructions
Products in use
It is important that both wood and product have a temperature of min. 15°C (preferably around 20°C) and air humidity of approximately 40-60 %. Make sure that the room is well-ventilated for optimal evaporation and drying time. Final sanding must be done with fine sandpaper (grit 120). Vacuum carefully afterwards. The surface must be free of dirt, grease, wax and dust. Shake the Master Base Primer thoroughly before use.

Always remember to test on a less visible spot to check the compatibility of the surface with the product.

  1. Apply the primer undiluted with brush or roller, following the wood along its length, and allow the surface to dry.
  2. Apply a layer of topcoat with one of the WOCA floor lacquers. Leave the surface to dry until next day.
  3. Sand the surface with and vacuum clean the surface thoroughly.
  4. Apply another 1-2 topcoats.
It is not recommended to apply more than two coats of primer/lacquer per day due to risk of excessive wood swelling.