Hardwax Oil Swift

Item No.: 528925A

Oiling and waxing of wooden floors

Good protection against liquids such as water, coffee, tea, and red wine
Durable and resistant to scratches and marks.
Does not need to be polished in
Long coverage

Colours

*The wood sample is shown on oak

Colourless – Matt

Packing

Certifications

Product Details

Hardwax Oil Swift is a fast-drying roll-on product for wooden floors, easy to apply without the need for polishing. It combines natural oils and waxes to create a durable surface with high resistance to liquids and stains. The floor acquires a neutral appearance and a non-slip, maintenance-friendly finish, making it ideal for the initial treatment of untreated, new, or newly sanded wooden surfaces.

Call a POISON CENTER or doctor if you feel unwell.
Warning!
Flammable liquid and vapour.
May cause drowsiness or dizziness.
Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking.

VOC:

510 g/l, maximum VOC content (A/i (SB)): 500 g/l.

Density:

0.90-0.95 g/ml.

Shelf life:

3 years

Application Temperature:

+15-25°C and approx. 50% air humidity.

Coverage:

20 m²/L

Colour:

Colourless – Matt

Packaging:

2.5 L

It is important that the product, the room and the floor are at a temperature between 15°C and 30°C and that air humidity is approx. 50 %. Wood humidity must not exceed 12%. Make sure that the room is well-ventilated for optimal evaporation and drying time. The floor must be free of dirt, grease, wax and sanding residue. Previously treated floors should be sanded down to bare wood with grain 120-150. Vacuum thoroughly and wipe the floor down afterwards if necessary, using a tightly-wrung water-soaked cloth. Hardwax Oil Swift is ready for use.

Always remember to test on a less visible spot to check the compatibility of the surface with the product.

should be stirred thoroughly before and during use. Containers with different batch numbers should be mixed to avoid colour mismatch.

Apply a thin layer of oil using a short-bristled paint roller (3-4 mm) or similar, along the grain of the wood. Distribute the oil thoroughly.

Leave the floor to dry for 4-5 hours at 20°C. Drying time will vary by temperature, humidity and application quantity. Lower temperatures and/or higher humidity can extend drying time.

Repeat the treatment within if another coat of oil is required. A single coat of oil is normally enough for previously-oiled surfaces.

The newly-oiled floor can be used with caution the following day and is fully hardened after 7 days under normal indoor conditions. After 7 days the floor can be cleaned with WOCA Natural Soap or WOCA Oil Refreshing Soap, which gives the surface extra protection. For optimal adheasion floors previously treated must be intermediate sanded using a bordeaux pad before applying a layer of Hardwax Oil. Workstep 2 and 3 must be repeated within 24 hours if a second layer of oil is required.

Products you need