Item number:

Water Based Floor Finish

  • Gives the floor a raw, bare wood appearance and feel
  • Ultra-matte sheen
  • Indoor climate labeled
  • IBR-certified
  • Pure 2K Hardener (isocyanate and aziridine free)

1 Gallon

Product details

  • Description
  • Specifications
  • Technical data sheet
  • Safety data sheet


90 g/l. (max)

Shelf life:

2 years

Application Temperature:

+59-77°F and approx. 50% air humidity.


325-410 sq.ft./Gal


Colorless - Ultra-matte

Cleaning of tools:

Use water


+50-77°F. Keep out of reach of children. Do not expose to heat (e.g. sunlight). Store frost-free during winter and cool during summer.


1 Gallon


30-35 Sec. DIN Cup 4

Pot life:

The mixture must be used within 48 hours. Shake/stir thoroughly before use.

Mixing ratio:

2% or 3.381 FL.OZ. to 169.070 FL.OZ. lacquer.

Between coats:

2-3 hours at 68°F

Light use:

24 hours at 68°F


Wait 24 hours before putting furniture on the floor. Wait 8 days before covering with carpets and washing.If drying times are not followed, this can result in poor adhesion and reduced resistance. For each layer of floor finish, drying times will be increased. High temperature and low air humidity will reduce drying times. Low temperature and high air humidity will extend drying times.

Fully hard:

8 days at 68°F

WOCA RP 2K waterbased finish is designed to keep the natural look and feel of freshly sanded wood while protecting it from daily wear. This ultra-low gloss waterbased polyurethane is very easy to apply for exceptional results. Best applied over light colored woods, this product forms a protective shield to keep wood safe from scratches, stains and water. This product is made from non-yellowing resins and has added UV absorbers to help protect the wood from changing color due to UV exposure. The hardener is isocyanate and aziridine free. This indoor climate labeled water based finish provides a very healthy indoor air quality during the application and after. For complete application, care and use information please see our website or TDS.


Products in use
It is important that both wood and finish have a temperature of min. 59°F (preferably around 68°F) and air humidity of approx. 50%. Make sure that the room is well-ventilated for optimal evaporation and drying time. For the final sanding to bare wood, use grit 120-150 sandpaper or sanding pad. Vacuum thoroughly and tack the floor afterwards with a tightly-wrung water-soaked cloth. The floor should be completely dry before application of WOCA RP 2K

Always remember to test on a less visible spot to check the compatibility of the surface with the product.

  1. Mix WOCA 2K Pure hardener with the lacquer and shake thoroughly before use. Leave the mixture to stand for ten minutes before use, to allow the hardener to activate.
  2. Apply a coat of the mixture with a paint roller or brush and leave the floor to dry for 2-3 hours. Apply the second coat and leave the surface to dry until the next day. The floor can be sanded after .
  3. Sand the surface with 120-150 and vacuum clean the surface thoroughly.
  4. Apply the final coat of WOCA RP 2K with hardener (freshly mixed).
Water and coloured fluids, such as red wine and coffee, must be wiped off immediately to prevent staining.