Maintenance Gel

Item number:

Revitalises oil-treated wood

  • Especially suitable for UV-oiled surfaces
  • Excellent results on factory-oiled surfaces
  • Makes surfaces even more durable
  • Simple application both manually and by machine 
  • Safe use according to EN 71-3

*The wood sample is shown on oak

6.763 FL.OZ.

Product details

  • Description
  • Specifications
  • Technical data sheet
  • Safety data sheet


130 g/l, maximum VOC content (A/i (SB)): 500 g/l.


0.90-0.95 g/ml.

Shelf life:

3 years

Application Temperature:

+59-77°F and approx. 50% air humidity.


Natural, Extra White

Cleaning of tools:

Use WOCA Solvent or turpentine


+50-77°F. Keep out of reach of children. Do not expose to heat (e.g. sunlight). Store frost-free during winter and cool during summer.







Solid content:


Mixing ratio:

Ready to use. Do not dilute.

Between coats:

4-6 hours at 68°F

Light use:

4-6 hours at 68°F


The oiled surface should not be exposed to water for the first 2-3 days, as this can cause stains and discoloration. Wood humidity must not exceed 18%. High temperature and low air humidity will shorten drying times. Low temperature and high air humidity will extend drying times.

Fully hard:

3 days at 68°F


Repeat the oil treatment when required.

Maintenance Gel is for the care and maintenance of oiled indoor wooden surfaces and floors. The oil is quick-drying and leaves an attractive, water and dirt-repellent surface. Maintenance Gel is suitable for furniture, kitchen work surfaces, floors and other indoor wooden surfaces. It can also be used for improved results on factory-oiled/UV-oiled surfaces.


Products in use
It is important that both wood and oil are at a temperature of at least 59°F, and ideally about 68°F, and that air humidity is approx. 50 %. Make sure that the room is well-ventilated, for optimal evaporation and drying time. Thoroughly clean the surface with Intensive Wood Cleaner, mixed 1 part cleaner to 20 parts water. Then wash with clean water. After cleaning, leave the surface to dry for at least 8 hours, at 68°F.

Always remember to test on a less visible spot to check the compatibility of the surface with the product.

  1. Thoroughly clean the surface with Intensive Wood Cleaner , mixed 1:20. Then wash with clean water. After cleaning, leave the surface to dry for at least 8-9 hours
  2. Sand the surface with 180 and vacuum clean the surface thoroughly.
  3. Apply an appropriate amount of gel to a Hand Scrubber Flex Kit White and distribute over the surface in a thin, even coat. Continue polishing until the wood seems saturated and the surface has a uniform appearance. It is recommended to work on small areas at a time, as the gel is quick-drying. For larger areas (floors larger than 40 sq.ft./L) it would be advantageous to use a polishing machine.
  4. Remove excess Maintenance Gel with dry, lint-free cotton cloths or pads until the surface no longer appears wet.
  5. If the wood does not seem fully saturated after 4-6 hours, repolish with less gel than the first treatment, but follow the same procedure.
  6. Wait 4-6 hours before using the surface. Avoid getting water or dirt on the wooden surface for the next 3 days .
When used on UV-oiled surfaces, make sure to do a more thorough final polishing to remove all excess gel.