Basic Pro 1K Lacquer

Item number:

All round water-based solution for domestic areas

  • Easy application
  • No primer needed
  • Easy to sand
  • Water-based
  • Danish Indoor Climate

5 L

Product details

  • Description
  • Specifications
  • Technical data sheet
  • Safety data sheet

VOC:

95 g/l, maximum VOC content (A/e (WB)): 130 g/l.

Density:

1.00-1.10 g/ml.

pH-value:

pH 7-8

Shelf life:

2 years

Application Temperature:

+15-25°C and approx. 50% air humidity.

Coverage:

8-10 m²/L

Colours:

Colourless - Silk-matt

Cleaning of tools:

Use water

Storage:

+10-25°C. Keep out of reach of children. Do not expose to heat (e.g. sunlight). Store frost-free during winter and cool during summer.

Packaging:

5 L

Viscosity:

20-25 Sec. DIN Cup 4

Dilution:

Undiluted

Odour:

Faint

Between coats:

2-3 hours at 20°C

Light use:

4-6 hours at 20°C

Recommendation:

Wait 24 hours before putting furniture on the floor. Wait 5-7 days before covering with carpets and washing. If drying times are not followed, this can result in poor adhesion and reduced resistance. For each coat of lacquer, drying times will be increased. High temperature and low air humidity will reduce drying times. Low temperature and high air humidity will extend drying times.

Fully hard:

7 days at 20°C

Basic Pro 1K Lacquer is a water-based floor lacquer with low odour, that leaves the wood with a resistant and durable surface ideal for normal wear. The lacquer has a good performance and is suitable for domestic projects due to its remarkable flow and fast drying time.

Worksteps

Instructions
Products in use
It is important that both wood and lacquer have a temperature of min. 15°C (preferably around 20°C) and air humidity of approx. 50%. Make sure that the room is well-ventilated for optimal evaporation and drying time. For the final sanding to bare wood, use grit 100-120 sandpaper or sanding pad. Vacuum thoroughly and wipe the floor down afterwards, using a tightly-wrung water-soaked mop/cloth. Please note: WOCA Intensive Wood Cleaner can help to remove contaminates from fully sanded wooden floors before lacquering. Please allow the floor to fully dry overnight. The floor must be completely dry before lacquering.

Always remember to test on a less visible spot to check the compatibility of the surface with the product.

  1. A coat of Basic Pro 1K Lacquer Lacquer should be applied undiluted, using a brush or roller. Leave the surface to dry until next day.
  2. Sand the surface with 120-200 and vacuum clean the surface thoroughly.
  3. Apply the final coat of undiluted Basic Pro 1K Lacquer.
Water and coloured fluids, such as red wine and coffee, must be wiped off immediately to prevent staining.