Master Invisible 2K Lacquer

Item No.: 690196A

Wood floor lacquer with a natural raw look

2-component floor lacquer with a raw natural look
Modern isocyanate-free hardener givers the product a 48 hours potlife
Ultra-Matt gloss level 5
Easy application
Anti-slip R10

Colours

*The wood sample is shown on oak

Colourless – Ultra-matt

Packing

Certifications

Product Details

Master Invisible 2K Lacquer is a premium, water-based ultra-matt floor finish designed to provide wood with a natural, raw appearance and feel. Utilizing Invisible technology, it leaves the surface with a texture that mimics freshly sanded wood. The lacquer uses a modern, isocyanate-free hardener, offering a potlife of up to 48 hours. It is also certified with the indoor climate label.

Contains : 1,2-benzisothiazol-3(2H)-one, reaction mass of 5-chloro-2-methyl-2H-isothiazol-3-one and 2-methyl-2H-isothiazol-3-one (3:1) and 2-methylisothiazol-3(2H)-one.. May produce an allergic reaction.
Safety data sheet available on request.

VOC:

90 g/l, maximum VOC content (A/e (WB)): 130 g/l.

Density:

1.00-1.10 g/ml.

Shelf life:

1 year

Application Temperature:

+15-25°C and approx. 50% air humidity.

Coverage:

8-10 m²/L

Colour:

Colourless – Ultra-matt

Packaging:

5 L

It is important that both wood and lacquer have a temperature of min. 15°C (preferably around 20°C) and air humidity of approx. 50 %. Make sure that the room is well-ventilated for optimal evaporation and drying time. For the final sanding to bare wood, use grit 120-150 sandpaper or sanding pad. Vacuum carefully afterwards. The surface must be free of dirt, grease, wax and dust. The floor should be completely dry before application of Master Invisible 2K lacquer.

Always remember to test on a less visible spot to check the compatibility of the surface with the product.

Mix WOCA with the lacquer and shake thoroughly before use. Leave the mixture to stand for ten minutes before use, to allow the hardener to activate.

Apply a coat of the mixture with a paint roller or brush and leave the floor to dry for . Apply the second coat and leave the surface to dry until the next day. The floor can be sanded after .

Sand the surface with and vacuum clean the surface thoroughly.

Apply the final coat of with hardener (freshly mixed).

Water and coloured fluids, such as red wine and coffee, must be wiped off immediately to prevent staining.

Products you need